Field distributors streamline drive connection
with the power supply system, DC 24 V control voltage and fieldbus.
They are based on bus interface technology with additional connection
technology for network distribution. The field distributor is installed
close to the motor, which facilitates decentralized installation.
Field distributors Z.1, Z.3 and Z.7 are available as an option in
an IP66 enclosure (protected against powerful water jets even if
water contains acidic or caustic additives). These field distributors
are the perfect match for MOVIMOT® and
MOVI-SWITCH® for fast, economical
and flexible decentralization of your system.
SEW-EURODRIVE components for decentralized
drive engineering are available with the IP66 enclosure as an option.
A range of additional optional measures and the use of special materials
allow components to be used in extreme ambient conditions, such as
with acidic or caustic cleaning additives. Option package for field
distributors and fieldbus interfaces:
- IP66 enclosure
- Stainless steel screw fittings pressure compensation
- M12 metal plug for fieldbus modules with M12 plug connectors
Option package for MOVIMOT® and
- OS surface protection
- IP66 terminal box with or without pressure compensation
- Optimized cable entry position
- Increased resistance to condensation
- Stainless steel fittings
Optional MF.. fieldbus interfaces allow MOVIMOT® and MOVI-SWITCH® drives
to connect to a standardized fieldbus system. These fieldbus interfaces
not only allow for controlling MOVIMOT® and
MOVI-SWITCH® drives, but also
for reading sensor signals as well as controlling actuators via
the digital input and output terminals. All fieldbus interfaces
and field distributors come with the IP65 enclosure as standard.
The fieldbus interfaces may be mounted, as required, directly on
the drive, offset in the field, or in the field distributor. The
following fieldbus interfaces are available:
The optional fieldbus interfaces of the MQ..
type are based on the same housing and fieldbus technology as type
MF… fieldbus interfaces, but are additionally equipped with an integrated
controller featuring the following functions:
- Simple positioning with NV26 or ES16 proximity sensors
- Integrated I/O preprocessing and timing elements
- Protocol modification
for MF../MQ.. fieldbus interfaces
The MFG11A keypad
is plugged onto any MFZ.. connection module instead of a fieldbus interface,
and so allows manual control of a MOVIMOT® drive.
DBG60B keypad can be used to control MOVIMOT® drives
via a fieldbus interface in manual mode. The process data words
can also be displayed in monitor mode.
DBG60B keypad is connected directly to the diagnostic interface
of the MF..MQ.. fieldbus interface.
Our hybrid cables were developed in-house
and are combination cables that carry the power supply, control
voltage and communication strands in one cable sheath. They also
ensure optimum EMC shielding and impedance. The hybrid cable for
connecting MOVIMOT® to field
distributors combines the communication interface and supply and control
voltage connections in one cable and is supplied as a pre-fabricated
cable with a plug-in connection. MOVIMOT® drives
with attached hybrid cables are easy to connect to field distributors
and ready for use. They are ideal for all systems with high demands on